E061 E100 Error Codes iR6570 Series iR5075 Series

Symptom

* E061-0001 (Potential ON)
* E061-0002 (Potential OFF)
* E100-0001
* E227-0004
Cause
* The pin is broken on the Primary Fan 2 Duct. The Laser Shutter is activated by the pin on the Primary Fan Duct Assembly. The linkage is pinched not allowing the laser shutter to be fully actuated (may also indicate E227-0004). Faulty Laser Scanner Assembly.
* Defective DC Controller PCB Assembly.

Action

1. Check the shutter operation and the pin on the Primary Fan Duct Assembly. If the
pin is broken replace the Primary Fan 2 Duct (iR6570 : FC6-3540-000 / iR5075
FL2-5834-000) or the Primary Fan Duct Assembly (iR6570 : FM2-3074-000 / iR5075
FM2-9694-000). If the Laser Scanner Assembly (iR6570 : FM2-3670-000 / iR5075
FM2-9832-000) has been replaced and error codes E100-0001/ E227-0004 are
intermittently indicated, proceed to the next step.
2. Remove the Primary Fan Duct Assembly (this assembly has a pin on it
that activates the laser shutter).
3. Remove and reinstall the Laser Scanner Assembly.
4. Install the Primary Fan Duct Assembly. This should free the linkage
allowing the laser shutter to be fully actuated.
5. Finally a DC Con clear resolved both of the intermittent issues (E100-0001/
E227-0004)

Blank Image or Dark Fogging Image (Including Blank Areas) and E061-0001 / E061-0002 Errors Occur : iR6570 Series
Approved

Symptom

* Blank copies,Dark fogging
* E061-0001 and E061-0002

Action

When the above error code/image problems are experienced, perform the following:

1. Check the potential sensor wiring harness for any damage. This is caused by the harness being trapped between the hopper assembly and the cable tie head.
2. If the cable is damaged repair or replace as necessary.
3. Reposition the head of the cable ties on the cable guide in a downward position.
4. Input "1" under Service Mode > COPIER > FUNCTION > DPC > DPC, press the OK key and switch the Main power off and on so as to forcibly execute the Potential Control.

Canon Error Code E073 E074 E075 E076 E077 E079 E080 E081 E082 E083 E084 E085 E086 E089 E090 E091 E100

E073 The transfer drawer connector or the transfer frame drawer connector is not connected as the front door is closed.
E073 The transfer drawer connector or the transfer frame drawer
connector is not connected as the front door is closed.
E074 The transfer belt unit does not reach the target position within a specific time.
E075 The transfer belt is off to the side.
E076 The transfer belt web is wound up
completely.
E077 The motor inside the transfer belt unit
has a fault.
E079 The home position (to apply pressure) of the transfer drum cleaner unit cannot be detected.
E080 An error occurs in the communication with the multi color unit controller PCB.
E081 The vertical motor clock is faulty.
unit E081 The vertical motor clock is faulty.
E082 The horizontal motor clock is faulty.
E083 The CD unit horizontal movement right sensor is faulty.
E084 The CD unit horizontal movement left sensor is faulty.
E085 The CD unit feeder release sensor is faulty.
E086 The CD unit claw release is faulty.
E089 A malfunction of the multi color
E090 The document feed motor is not
functioning properly.
E091 A failure in the detection of the document feed sensor.
E100 The BD signal cannot be detected within a specific time.